Alumarail Aluminum Railing Parts.
..Home Page.. || ..Back to Instructions Page..
An even larger photo above
Part description by letter shown in the photo.
A. Base 5" x 5"
B. Post section. Width of post is 2-3/8" and height is usually pre-cut at factory with base installed.
C. Is the larger of two clips that go on the post to support the bottom rail. This one is the heavier of the two.
D. The heavier bottom rail that we use for glass and cable.
E. The small infill to fill the gap in the top of the bottom rail.
F. A secion of the smaller glass vinyl used in the bottom rail if using glass.
G. The smaller of two end caps for the Series 200 flat top rail.
H. The cable infill for both styles of top rail shown.
I. Original 200 Series top rail used as a continuous 3-1/2" wide top rail. Provides a lot of strength to system especially for cable.
J. A newer version of the top rail. Has a softer look when installed because of the oval shape.
K. The glass and picket infill for both styles of the top rail shown.
L. Larger glass vinyl for the larger pocket in the infill secion shown in "K".
M. Larger of two end caps and is used when attaching directly to a wall, wooden column or another taller aluminum
post at the head of a stair section.
N. Small glass vinyl as in "F" shown used in the Series 100 bottom rail "P".
O. Curved snap cover for top of the Series 100 bottom rail and sometimes used on the bottom of the large top rails.
P. Series 100 bottom rail.
Q. Smaller of two bottom clips used in the Series 100 bottom rail and the Round Series 100 top rail "S".
R. A short piece of picket with two pieces of Picket Vinyl shown.
S. Series 100 round top rail. Used for top or a railing system between the posts or stairway top railing going down the stairs.
..Home Page..||..Return to Instructions Page ..